**** Advance Notice ****

This site will be closed on 31 December 2015,

Important Information for users of NXP LPCXpresso

This site is for users of Code Red branded products.

NXP LPCXpresso users should visit the LPCXpresso FAQ's for up-to-date information relevant to that product.

RDB1768 External Power Supply

In most cases, the RDB1768 will be powered via USB - either using the built-in debug connector (J9) or the USB device connector (J11).

However it is also possible to power the board via the PSU connector (J6), which is a KLDX-SMT-0201LB part (1.3mm) and the tip is hot (the pin/hole in the middle is +VE).


In order to take power from this rather than USB, put a jumper across J26.

The external power supply should be 5V regulated (maximum 6V regulated) and should be 300mA (plus whatever your USB host load is).

RDBExternalPSU (last edited 2012-02-08 09:42:56 by CrSupportAb)