**** Advance Notice ****

This site will be closed on 31 December 2015,

Important Information for users of NXP LPCXpresso

This site is for users of Code Red branded products.

NXP LPCXpresso users should visit the LPCXpresso FAQ's for up-to-date information relevant to that product.

External Debug Connector

The RDB1768 is fitted with a standard 10-pin 0.05" pitch JTAG connector to allow the connection of any external debug probe. When an external probe is connected the on-board debug circuit is disabled.

Picture of JTAG Connector

JTAG 10-pin connector pinout

Note that pin 1 of the connector is the bottom right pin in the above picture. This is labelled on the RDB1768V2, but not on the original RDB1768 (version 1). Make sure that you connect the cable from your external probe appropriately (pin 1 on the cable normally being indicated by the red stripe).

More information on debug connections can be found in the FAQ SWD/JTAG connectors and pinout.

ExternalDebug (last edited 2012-02-08 08:32:14 by CrSupportAb)