**** Advance Notice ****

This site will be closed on 31 December 2015,

Important Information for users of NXP LPCXpresso

This site is for users of Code Red branded products.

NXP LPCXpresso users should visit the LPCXpresso FAQ's for up-to-date information relevant to that product.

Connecting Red Probe+ to the MCU of an LPCXpresso board

The LPCXpresso board was not designed with connecting an external probe, such as Red Probe+, in mind. However it is relatively straight forward to do so.

Note in particular that you cannot just connect a Red Probe+ to the debug connector (J5) on the LPCXpresso board. The J5 debug connector is output only - it is designed to allow the LPC-Link of the LPCXpresso board to debug an external board.

Splitting the LPCXpresso board

Before you can connect your Red Probe+, you will need to split the MCU portion of your LPCXpresso board from the LPC-Link portion. Details of how to go about doing this can be found in the FAQ Debugging another board using an LPCXpresso board's LPC-Link.

Note

Before making modifications to your LPCXpresso board and connecting your Red Probe+, you may wish to check the schematics for the actual LPCXpresso board variant that you are using. NXP currently have schematics available from:

Debug connection

Having split your LPCXpresso board, you will then need to connect the Red Probe+ to the MCU portion of the LPCXpresso board as follows:

LPCXpresso board

20 pin Red Probe+ connector

JTAG_VTREF - J4-2

 P1 - VTREF/VCC

JTAG_TMS   - J4-4

 P7 - TMS

JTAG_TCLK  - J4-6

 P9 - TCLK

JTAG_TDO   - J4-8

P13 - TDO

JTAG_TDI   - J4-10

 P5 - TDI

GND        - J4-16

P20 - GND

Note that details of the Red Probe+ debug connector can be found in the FAQ SWD/JTAG connectors and pinout.

Typically, pin 1 of the 20-way Red Probe+ cable is indicated by the "red stripe".

Power

The MCU portion of the LPCXpresso board is usally powered from the LPC-LINK end of the board. When the connections across J4 are cut, you need to have another power source for the target. 3v3 can be supplied to J6-28 and GND to J6-1.

ExtProbe2LPCXpresso (last edited 2013-03-18 17:37:58 by CrSupportAb)