**** Advance Notice ****

This site will be closed on 31 December 2015,

Important Information for users of NXP LPCXpresso

This site is for users of Code Red branded products.

NXP LPCXpresso users should visit the LPCXpresso FAQ's for up-to-date information relevant to that product.

Connecting to a JTAG target

When connecting to a Cortex-M part, by default, the debugger will attempt to connect using SWD. If you need to connect via JTAG, then you must make a debugger configuration change as follows:

The debugger will now connect using JTAG instead of SWD.

The first time that you connect to a target over JTAG, a pop up dialog will appear for you to select which device on the JTAG scan chain to connect to. For more details see the FAQ "Multiple devices on a JTAG scan chain.


Note

Some Cortex-M based MCU's only support debugging via SWD, and not via JTAG. Please check the documentation for the MCU that you are using for more information.

ConnectingToJtag (last edited 2012-05-09 13:38:31 by CrSupportAb)